Cisco Catalyst 3750 Metro - Ethernet Lmi Ce-Vlan Map

2-112
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
ethernet lmi ce-vlan map
ethernet lmi ce-vlan map
Use the ethernet lmi ce-vlan map Ethernet service configuration command to configure Ethernet Local
Management Interface (E-LMI) parameters. Use the no form of this command to remove the
configuration.
ethernet lmi ce-vlan map {vlan-id | any | default | untagged}
no ethernet lmi ce-vlan map {vlan-id | any | default | untagged}
Syntax Description
Defaults No E-LMI mapping parameters are defined.
Command Modes Ethernet service configuration
Command History
Usage Guidelines Use this command to configure an E-LMI customer VLAN-to-EVC map for a particular user-network
interface (UNI).
E-LMI mapping parameters are related to the bundling characteristics set by entering the ethernet uni
{bundle [all-to-one] | multiplex} interface configuration command.
• Using the default UNI attribute (bundling and multiplexing) supports multiple EVCs and multiple
VLANs.
• Entering the ethernet uni bundle command supports only one EVC with one or more VLANs.
• Entering the ethernet uni bundle all-to-one command supports multiple VLANs but only one EVC.
If you use the ethernet lmi ce-vlan map any Ethernet service configuration command, you must
first configure all-to-one bundling on the interface.
• Entering the ethernet uni multiplex command supports multiple EVCs with only one VLAN per
EVC.
vlan-id Enter the customer VLAN ID or VLAN IDs to map to. You can enter a single
VLAN ID (the range is 1 to 4094), a range of VLAN IDs separated by a
hyphen, or a series of VLAN IDs separated by commas.
any Map all VLANs (untagged and VLANs 1 to 4094).
default Map to the default service instance. You can use the default keyword only if
you have already mapped the service instance to a VLAN or a group of
VLANs.
untagged Map only untagged VLANs.
Release Modification
12.2(25)SEG This command was introduced.