2-458
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show errdisable flap-values
show errdisable flap-values
Use the show errdisable flap-values user EXEC command to display conditions that cause an error to
be recognized for a cause.
show errdisable flap-values
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Usage Guidelines The Flaps column in the display shows how many changes to the state within the specified time interval
will cause an error to be detected and a port to be disabled. For example, the display shows that an error
will be assumed and the port shut down if three Dynamic Trunking Protocol (DTP)-state (port mode
access/trunk) or Port Aggregation Protocol (PAgP) flap changes occur during a 30-second interval, or if
5 link-state (link up/down) changes occur during a 10-second interval.
ErrDisable Reason Flaps Time (sec)
----------------- ------ ----------
pagp-flap 3 30
dtp-flap 3 30
link-flap 5 10
Examples This is an example of output from the show errdisable flap-values command:
Switch> show errdisable flap-values
ErrDisable Reason Flaps Time (sec)
----------------- ------ ----------
pagp-flap 3 30
dtp-flap 3 30
link-flap 5 10
Release Modification
12.1(14)AX This command was introduced.
To Next Page
Loading...
