2-576
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show mvr interface
show mvr interface
Use the show mvr interface privileged EXEC command without keywords to display the Multicast
VLAN Registration (MVR) receiver and source ports. Use the command with keywords to display MVR
parameters for a specific receiver port.
show mvr interface [interface-id [members [vlan vlan-id]]]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines If you enter only the show mvr interface command, the output shows all MVR-enabled ports on the
switch.
If you enter the show mvr interface interface-id command and the specified port is a non-MVR port,
the output displays NON MVR in the Type field. For active MVR ports, it displays the port type
(RECEIVER or SOURCE), mode (access or trunk), VLAN, status, and Immediate-Leave setting.
If you enter the members keyword, all MVR group members on the interface are displayed. If you enter
a VLAN ID, all MVR group members in the VLAN are displayed.
Examples This is an example of output from the show mvr interface command:
Switch# show mvr interface
Port Type Mode VLAN Status Immediate Leave
---- ---- ---- ---- ------- ---------------
Fa0/1 Receiver Trunk 1 ACTIVE/UP DISABLED
Fa0/1 Receiver Trunk 2000 ACTIVE/DOWN DISABLED
Fa0/2 Receiver Trunk 2 ACTIVE/UP DISABLED
Fa0/2 Receiver Trunk 3000 ACTIVE/UP DISABLED
Fa0/3 Receiver Trunk 2 ACTIVE/UP DISABLED
Fa0/3 Receiver Trunk 3000 ACTIVE/UP DISABLED
Fa0/10 Source Access 10 ACTIVE/UP DISABLED
interface-id (Optional) Display MVR type, status, and Immediate Leave setting for the
interface.
Valid interfaces include physical ports (including type, module, and port
number.
members (Optional) Display all MVR groups to which the specified interface belongs.
vlan vlan-id (Optional) Display all MVR group members on this VLAN. The VLAN ID
range is 1 to 1001 and 1006 to 4094.
Release Modification
12.1(14)AX This command was introduced.
12.2(35)SE The Mode and VLAN fields were added to the output display.
To Next Page
Loading...
