2-522
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show ipv6 route updated
show ipv6 route updated
Use the show ipv6 route updated command in user EXEC command to display the current contents of
the IPv6 routing table.
show ipv6 route [protocol] updated [boot-up]{hh:mm | day{month [hh:mm]} [{hh:mm |
day{month [hh:mm]}]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the show ipv6 route privileged EXEC command to display the current contents of the IPv6 routing
table.
Examples This is an example of output from the show ipv6 route updated rip command.
Switch> show ipv6 route rip updated
IPv6 Routing Table - 12 entries
Codes: C - Connected, L - Local, S - Static, U - Per-user Static route
B - BGP, R - RIP, I1 - ISIS L1, I2 - ISIS L2
protocol (Optional) Displays routes for the specified routing protocol using any of
these keywords:
• bgp
• isis
• ospf
• rip
or displays routes for the specified type of route using any of these keywords:
• connected
• local
• static
• interface interface id
boot-up Display the current contents of the IPv6 routing table.
hh:mm Enter the time as a 2-digit number for a 24-hour clock. Make sure to use the
colons (:). For example, enter 13:32
day Enter the day of the month. The range is from 1 to 31.
month Enter the month in upper case or lower case letters. You can enter the full
name of the month, such as January or august, or the first three letters of the
month, such as jan or Aug.
Release Modification
12.2(52)SE This command was introduced.
To Next Page
Loading...
