Cisco Catalyst 3750 Metro - Show Ip Sla Twamp Session

2-509
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show ip sla twamp session
show ip sla twamp session
Use the show ip sla twamp session command in user EXEC mode to display Cisco IOS IP Service Level
Agreements (SLAs) Two-Way Active Measurement Protocol (TWAMP) test sessions.
show ip sla twamp session [source-ip ip address | source-port port-number]
Syntax Description
Defaults Displays the IP SLAs TWAMP test sessions and results.
Command Modes User EXEC
Command History
Usage Guidelines Use the show ip sla twamp session command to display information about IP SLAs TWAMP test
sessions.
Examples The following is sample output from the show ip sla twamp session command:
Switch> show ip sla twamp session
IP SLAs Responder TWAMP is: Enabled
Recvr Addr: 172.27.117.116
Recvr Port: 3619
Sender Addr: 172.27.111.225
Sender Port: 32910
Session Id: 172.27.117.116:533112:9C41EC42
Connection Id: 95
Related Commands
source-ip ip-address (Optional) Display results from the TWAMP test session on the specified IP
address.
source-port
port-number
(Optional) Display results from the TWAMP test session on the specified
port.
Release Modification
12.2(52)SE This command was introduced.
Command Description
show ip sla standards Displays the TWAMP server and reflector standards implemented on the
switch.
show ip sla twamp
connection {detail |
requests}
Displays IP SLAs TWAMP connections.