Cisco Catalyst 3750 Metro - Show Boot

2-437
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show boot
Note Though visible in the display, the Auto upgrade field is not supported.
Related Commands
Ta b l e 2-19 show boot Field Descriptions
Field Description
BOOT path-list Displays a semicolon separated list of executable files to try to
load and execute when automatically booting.
If the BOOT environment variable is not set, the system attempts
to load and execute the first executable image it can find by using
a recursive, depth-first search through the flash file system. In a
depth-first search of a directory, each encountered subdirectory
is completely searched before continuing the search in the
original directory.
If the BOOT variable is set but the specified images cannot be
loaded, the system attempts to boot the first bootable file that it
can find in the flash file system.
Config file Displays the filename that the software uses to read and write a
nonvolatile copy of the system configuration.
Private Config file Displays the filename that the software uses to read and write a
nonvolatile copy of the system configuration.
Enable Break Displays whether a break during booting is enabled or disabled.
If it is set to yes, on, or 1, you can interrupt the automatic boot
process by pressing the Break key on the console after the flash
file system is initialized.
Manual Boot Displays whether the switch automatically or manually boots. If
it is set to no or 0, the boot loader attempts to automatically boot
the system. If it is set to anything else, you must manually boot
the switch from the boot loader mode.
Helper path-list Displays a semicolon separated list of loadable files to
dynamically load during the boot loader initialization. Helper
files extend or patch the functionality of the boot loader.
Command Description
boot config-file Specifies the filename that the software uses to read and write a nonvolatile
copy of the system configuration.
boot enable-break Enables interrupting the automatic boot process.
boot manual Enables manually booting the switch during the next boot cycle.
boot
private-config-file
Specifies the filename that software uses to read and write a nonvolatile copy
of the private configuration.
boot system Specifies the image to load during the next boot cycle.