Cisco Catalyst 3750 Metro - Debug Rep

B-83
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug rep
debug rep
Use the debug rep privileged EXEC command to enable debugging of Resilient Ethernet Protocol (REP)
functions. Use the no form of this command to disable debugging.
debug rep {all | bpa-event | bpasm | epasm | error | failure-recovery | lslsm | packet | prsm}
no debug rep {all | bpa-event | bpasm | epasm | error | failure-recovery | lslsm | packet | prsm}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug rep command is the same as the no debug rep command.
Related Commands
all Display all REP debug messages.
bpa-event Display blocked port advertisement (BPA) debug messages.
bpasm Display BPA state machine debug messages.
epasm Display end port advertisement (EPA) state machine debug messages.
error Display REP protocol error debug messages.
failure-recovery Display REP switchover event debug messages.
lslsm Display Link State Layer (LSL) state machine debug messages.
packet Display protocol PDU debug messages.
prsm Display REP port role state machine debug messages.
Release Modification
12.2(46)SE This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show interfaces rep Displays REP configuration and status for a specified interface or for all
interfaces.