Cisco Catalyst 3750 Metro - Debug Ip Sla Trace Twamp Control Reflector

B-25
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug ip sla trace twamp control reflector
debug ip sla trace twamp control reflector
Use the debug ip sla trace twamp control reflector command in privileged EXEC mode to enable
debugging output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement
Protocol (TWAMP) normal communications between the TWAMP server and reflector. Use the no form
of this command to disable debugging output.
debug ip sla trace twamp control reflector
no debug ip sla trace twamp control reflector
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines The debug ip sla trace twamp control reflector privileged EXEC command displays messages about
normal TWAMP session communications sent from the reflector to the server.
Note Use the debug ip sla error twamp control reflector command before using the debug ip sla trace
twamp control reflector command because the debug ip sla error twamp control reflector command
generates less debugging output.
The debug ip sla trace twamp control reflector command is supported in IPv4 networks.
The undebug ip sla trace twamp control reflector command is the same as the no debug ip sla trace
twamp control reflector command.
Release Modification
12.2(52)SE This command was introduced.