2-96
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
dot1x timeout
dot1x timeout
Use the dot1x timeout interface configuration command to set 802.1x timers. Use the no form of this
command to return to the default setting.
dot1x timeout {quiet-period seconds | reauth-period seconds | server-timeout seconds |
supp-timeout seconds | tx-period seconds}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
Syntax Description
Defaults These are the default settings:
reauth-period is 3600 seconds.
quiet-period is 60 seconds.
tx-period is 30 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
Command Modes Interface configuration
Command History
Usage Guidelines You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
quiet-period seconds Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
reauth-period seconds Number of seconds between re-authentication attempts. The range is 1to
65535.
server-timeout seconds Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 1 to 65535.
However, we recommend a minimum setting of
30.
supp-timeout seconds Number of seconds that the switch waits for the retransmission of packets
by the switch to the 802.1x client. The range is 30 to 65535.
tx-period seconds Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before resending the request.
The range is 1 to 65535.
Release Modification
12.1(14)AX This command was introduced.
12.2(40)SE The range for tx-period seconds is incorrect. The correct range is from 1 to
65535.
To Next Page
Loading...
