Cisco Catalyst 3750 Metro

C-8
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix C Catalyst 3750 Metro Switch Show Platform Commands
show platform ip igmp snooping
show platform ip igmp snooping
Use the show platform ip igmp snooping privileged EXEC command to display platform-dependent
Internet Group Management Protocol (IGMP) snooping information.
show platform ip igmp snooping {all | control [di] | counters | flood [vlan vlan-id] | group
ip-address | hardware | retry [count | local [count] | remote [count]]}
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with a technical support representative
while troubleshooting a problem. Do not use this command unless a technical support representative asks
you to do so.
all Display all IGMP snooping platform IP multicast information.
control [di] Display IGMP snooping control entries. The keyword has this meaning:
• di—(Optional) Display IGMP snooping control destination index
entries.
counters Display IGMP snooping counters.
flood [vlan vlan-id] Display IGMP snooping flood information. The keyword has this meaning:
• vlan vlan-id—(Optional) Display flood information for the specified
VLAN. The range is 1 to 4094.
group ip-address Display the IGMP snooping multicast group information, where ip-address is
the IP address of the group.
hardware Display IGMP snooping information loaded into hardware.
retry [count | local
[count]
Display IGMP snooping retry information. The keywords have these
meanings:
• count—(Optional) Display only the retry count.
• local—(Optional) Display local retry entries.
remote [count] Display remote entries. The keyword has this meaning:
• count—(Optional) Display only the remote count.
Release Modification
12.1(14)AX This command was introduced.