Cisco Catalyst 3750 Metro - Show Mpls L2 Transport VC

2-570
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show mpls l2transport vc
show mpls l2transport vc
Use the show mpl2 l2transport vc user EXEC command to provide information about the Ethernet over
multiprotocol label switching (EoMPLS) virtual circuits (VCs) that have been enabled to route Layer 2
packets on a provider-edge device.
show mpls l2transport vc [detail] [summary] [vc-id] [vc-id-min - vc-id-max]
Syntax Description
Command Modes User EXEC
Command History
Examples This is an example of output from the show mpls l2transport vc command:
Switch> show mpls l2transport vc
Transport Client VC Trans Local Remote Tunnel
VC ID Intf State Type VC Label VC Label Label
49 Vl60 UP vlan 18 18 implc-null
50 Vl80 DOWN vlan unassigned unassigned not ready
52 Fa1/0/2 UP ether 17 17 implc-null
Table 2-27 describes the fields in the display.
detail (Optional) Display provides detailed information about the VCs on a
provider-edge device.
summary (Optional) Display provides a summary of the configured VCs on the
provider-edge device MPLS interfaces.
vcid (Optional) Display information about the specified VC. The range is 1 to
4294967295.
vc-id-min - vc-id-max (Optional) Display information about the specified range of VCs. The range
is 1 to 4294967295.
Release Modification
12.1(14)AX This command was introduced.
Ta b l e 2-27 show mpls l2 transport vc Field Descriptions
Field Description
Transport VC ID The virtual circuit identifier assigned to one of the interfaces on the
device.
Client Intf The ingress or egress interface through which the Layer 2 VLAN
packet travels. The interface is a VLAN or a physical interface.