Cisco Catalyst 3750 Metro

B-27
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug ip sla trace twamp control server
debug ip sla trace twamp control server
Use the debug ip sla trace twamp control server command in privileged EXEC mode to enable
debugging output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement
Protocol (TWAMP) normal communications between the TWAMP server and reflector. Use the no form
of this command to disable debugging output.
debug ip sla trace twamp control server
no debug ip sla trace twamp control server
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines The debug ip sla trace twamp control server privileged EXEC command displays messages about
normal TWAMP session communications sent from the server to the reflector.
Note Use the debug ip sla error twamp control server command before using the debug ip sla trace twamp
control server command because the debug ip sla error twamp control server command generates less
debugging output.
The debug ip sla trace twamp control server command is supported in IPv4 networks.
The undebug ip sla trace twamp control server command is the same as the no debug ip sla trace
twamp control server command.
Release Modification
12.2(52)SE This command was introduced.