2-315
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
mls qos vlan-based
mls qos vlan-based
Use the mls qos vlan-based interface configuration command to enable VLAN-based quality of service
(QoS) on the physical port. Use the no form of this command to disable this feature.
mls qos vlan-based
no mls qos vlan-based
Syntax Description There are no arguments or keywords.
Defaults VLAN-based QoS is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines Before attaching a hierarchical dual-level policy map to a switch virtual interface (SVI), use the mls qos
vlan-based interface configuration command on a physical port if the port is to be specified in the
secondary interface level of the dual-level policy map.
When you configure dual-level policing, the dual-level policy map is attached to the SVI and affects all
traffic belonging to the VLAN. The individual policer in the interface-level traffic classification only
affects the physical ports specified for that classification.
For detailed instructions about configuring dual-level policy maps, see the “Classifying, Policing, and
Marking Traffic by Using Dual-Level Policy Maps” section in the software configuration guide for this
release.
Examples This example shows how to enable VLAN-based policing on a physical port:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# mls qos vlan-based
You can verify your settings by entering the show mls qos interface privileged EXEC command.
Related Commands
Release Modification
12.2(25)EY This command was introduced.
Command Description
show mls qos interface Displays QoS information.
To Next Page
Loading...
