Cisco Catalyst 3750 Metro

C-11
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix C Catalyst 3750 Metro Switch Show Platform Commands
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
show platform ip unicast {adjacency [A.B.C.D]| cef-idb | counts | dhcp | failed {adjacency | arp
[A.B.C.D] | route} | mpaths | proxy | route [A.B.C.D] | standby | statistics | trace}
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with a technical support representative
while troubleshooting a problem. Do not use this command unless a technical support representative asks
you to do so.
adjacency [A.B.C.D] Display the platform adjacency database. The keyword has this meaning:
• A.B.C.D—(Optional) Display adjacency information for the specified IP
address.
cef-idb Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
counts Display the current counts for the Layer 3 unicast databases.
dhcp Display the DHCP system dynamic addresses.
failed {adjacency |
arp [A.B.C.D] | route}
Display the hardware resource failures. The keywords have these meanings:
• adjacency—Display the adjacency entries that failed to be programmed
in hardware.
• arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
• A.B.C.D—(Optional) Prefix of the ARP entries to display.
• route—Display the route entries that failed to be programmed in
hardware.
mpaths Display the Layer 3 unicast routing multipath adjacency database.
proxy Display entries for the proxy Address Resolution Protocol (ARP) database.
route [A.B.C.D] Display the platform route database. The keyword has this meaning:
• A.B.C.D—(Optional) Display entries for the specified IP prefix.
standby Display the platform standby information.
statistics Display the Layer 3 unicast routing accumulated statistics.
trace Display the platform event trace logs.
Release Modification
12.1(14)AX This command was introduced.