Cisco Catalyst 3750 Metro - Snmp Trap Mac-Notification Change

2-639
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
snmp trap mac-notification change
snmp trap mac-notification change
Use the snmp trap mac-notification change interface configuration command to enable the Simple
Network Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface.
Use the no form of this command to return to the default setting.
snmp trap mac-notification {added | removed}
no snmp trap mac-notification {added | removed}
Syntax Description
Defaults By default, the traps for both address addition and address removal are disabled.
Command Modes Interface configuration
Command History
Usage Guidelines Even though you enable the notification trap for a specific interface by using the snmp trap
mac-notification change command, the trap is generated only when you enter the snmp-server enable
traps mac-notification change and the mac address-table notification change global configuration
commands.
Examples This example shows how to enable the MAC notification trap when a MAC address is added to a port:
Switch(config)# interface fastethernet1/0/4
Switch(config-if)# snmp trap mac-notification change added
You can verify your settings by entering the show mac address-table notification change interface
privileged EXEC command.
Related Commands
added Enable the MAC notification trap whenever a MAC address is added on this
interface.
removed Enable the MAC notification trap whenever a MAC address is removed from this
interface.
Release Modification
12.1(14)AX This command was introduced.
12.2(40)SE The change keyword was added.
Command Description
clear mac address-table notification Clears the MAC address notification global counters.
mac address-table notification Enables the MAC address notification feature.