Cisco Catalyst 3750 Metro - Page 666

2-638
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
snmp-server host
The no snmp-server host command with no keywords disables traps, but not informs, to the host. To
disable informs, use the no snmp-server host informs command.
Examples This example shows how to configure a unique SNMP community string named comaccess for traps and
prevent SNMP polling access with this string through access-list 10:
Switch(config)# snmp-server community comaccess ro 10
Switch(config)# snmp-server host 172.20.2.160 comaccess
Switch(config)# access-list 10 deny any
This example shows how to send the SNMP traps to the host specified by the name myhost.cisco.com.
The community string is defined as comaccess.
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com comaccess snmp
This example shows how to enable the switch to send all traps to the host myhost.cisco.com by using the
community string public:
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com public
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command Description
show running-config Displays the operating configuration. For syntax information, use this
link to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_comma
nd_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate
to the command.
snmp-server enable traps Enables SNMP notification for various trap types or inform requests.