Cisco Catalyst 3750 Metro - Show Sdm Prefer

2-592
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show sdm prefer
show sdm prefer
Use the show sdm prefer privileged EXEC command to display information about the Switch Database
Management (SDM) templates that can be used to maximize system resources for a particular feature,
or use the command without a keyword to display the template in use.
show sdm prefer [default | dual-ipv4-and-ipv6 {default | routing | vlan} routing | vlan]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines When you change the SDM template by using the sdm prefer global configuration command, you must
reload the switch for the configuration to take effect. If you did not reload the switch after entering the
sdm prefer global configuration command, the show sdm prefer privileged EXEC command displays
the template in use and not the newly configured template.
The numbers displayed for each template represent an approximate maximum number for each feature
resource. The actual number might vary, depending on the actual number of other features configured.
Examples This is an example of output from the show sdm prefer command, displaying the template in use:
Switch# show sdm prefer
The current template is “desktop default” template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 6K
number of igmp groups + multicast routes: 1K
number of unicast routes: 8K
number of directly connected hosts: 6K
default (Optional) Display the template that balances system resources among
features.
dual-ipv4-and-ipv6
{default | routing |
vlan)
(Optional) Display the dual templates that support both IPv4 and IPv6.
• default—Display the default dual template configuration.
• routing—Display the routing dual template configuration.
• vlan—Display the VLAN dual template configuration.
routing (Optional) Display the template that maximizes system resources for routing.
vlan (Optional) Display the template that maximizes system resources for Layer 2
VLANs.
Release Modification
12.1(14)AX This command was introduced.
12.2(25)EY The routing-pbr keywords were removed.
12.2(52)SE The dual-ipv4-and-ipv6 {default | vlan| routing} keywords were added.