2-433
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show auto qos
show auto qos
Use the show auto qos user EXEC command to display the initial configuration that is generated by the
automatic quality of service (auto-QoS) feature.
show auto qos [interface [interface-id]]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines In releases earlier than Cisco IOS Release 12.2(25)EY, the show auto qos [interface [interface-id]]
command output shows the initial generated auto-QoS configuration.
In Cisco IOS Release 12.2(25)EY or later, the show auto qos command output shows only the auto-QoS
command entered on each interface. The show auto qos interface interface-id command output shows
the auto-QoS command entered on a specific interface.
Use the show running-config privileged EXEC command to display the auto-QoS configuration and the
user modifications.
On an enhanced-services (ES) port, the srr-queue bandwidth shape interface configuration command
is not part of the generated auto qos voip command list.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
• show mls qos
• show mls qos maps cos-dscp
• show mls qos interface [interface-id] [buffers | queueing]
• show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
• show mls qos input-queue
• show running-config
Examples This is an example of output from the show auto qos command after the auto qos voip cisco-phone and
the auto qos voip cisco-softphone interface configuration commands are entered:
Switch> show auto qos
GigabitEthernet1/0/1
auto qos voip cisco-softphone
GigabitEthernet1/0/2
interface [interface-id] (Optional) Display auto-QoS information for the specified port or
for all ports.
Release Modification
12.1(14)AX This command was introduced.
To Next Page
Loading...
