EasyManuals Logo

Cisco Catalyst 3750 Metro User Manual

Cisco Catalyst 3750 Metro
985 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
2-143
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
ip arp inspection vlan logging
ip arp inspection vlan logging
Use the ip arp inspection vlan logging global configuration command on the switch to control the type
of packets that are logged per VLAN. Use the no form of this command to disable this logging control.
ip arp inspection vlan vlan-range logging {acl-match {matchlog | none} | dhcp-bindings {all |
none | permit} | arp-probe}
no ip arp inspection vlan vlan-range logging {acl-match | dhcp-bindings | arp-probe}
Syntax Description
Defaults All denied or all dropped packets are logged. ARP probe packets are not logged.
Command Modes Global configuration
Command History
Usage Guidelines The term logged means that the entry is placed into the log buffer and that a system message is generated.
vlan-range Specify the VLANs configured for logging.
You can specify a single VLAN identified by VLAN ID number, a range of
VLANs separated by a hyphen, or a series of VLANs separated by a comma.
The range is 1 to 4094.
acl-match {matchlog |
none}
Specify that the logging of packets is based on access control list (ACL)
matches.
The keywords have these meanings:
• matchlog—Log packets based on the logging configuration specified in
the access control entry (ACE). If you specify the matchlog keyword in
this command and the log keyword in the permit or deny Address
Resolution Protocol (ARP) access-list configuration command, ARP
packets permitted or denied by the ACL are logged.
• none—Do not log packets that match ACLs.
dhcp-bindings
{permit | all | none}
Specify the logging of packets is based on DHCP binding matches.
The keywords have these meanings:
• all—Log all packets that match DHCP bindings.
• none—Do not log packets that match DHCP bindings.
• permit—Log DHCP-binding permitted packets.
arp-probe Specify logging of packets permitted specifically because they are ARP
probes.
Release Modification
12.2(25)EY This command was introduced.
12.2(37)SE The arp-probe keyword was added.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750 Metro and is the answer not in the manual?

Cisco Catalyst 3750 Metro Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3750 Metro
CategorySwitch
LanguageEnglish

Related product manuals