2-456
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show errdisable detect
show errdisable detect
Use the show errdisable detect user EXEC command to display error-disabled detection status.
show errdisable detect
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Usage Guidelines The Mode column shows the shutdown mode that was configured for the error-disabled reason:
• port—The physical port is error disabled if a violation occurs.
• vlan—The virtual port is disabled if a violation occurs.
• port/vlan—Some ports are configured for physical port disable, and others are configured for virtual
port disable. Enter the show running config privileged EXEC command to see the configuration for
each port.
A displayed gbic-invalid error in the Reason column refers to an invalid small form-factor pluggable
(SFP) interface.
Examples This is an example of output from the show errdisable detect command:
Switch> show errdisable detect
ErrDisable Reason Detection Mode
----------------- --------- ----
arp-inspection Enabled port
bpduguard Enabled port
channel-misconfig Enabled port
community-limit Enabled port
dhcp-rate-limit Enabled port
dtp-flap Enabled port
gbic-invalid Enabled port
invalid-policy Enabled port
l2ptguard Enabled port
link-flap Enabled port
link-monitor-fail Enabled port
loopback Enabled port
lsgroup Enabled port
oam-remote-failur Enabled port
pagp-flap Enabled port
psecure-violation Enabled port/vlan
security-violatio Enabled port
sfp-config-mismat Enabled port
storm-control Enabled port
Release Modification
12.1(14)AX This command was introduced.
12.2(37)SE The Mode column was added to the output display.
To Next Page
Loading...
