Cisco Catalyst 3750 Metro - Show Dot1 X

2-451
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show dot1x
PortStatus = UNAUTHORIZED
MaxReq = 2
HostMode = Multi
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
This is an example of output from the show dot1x interface interface-id command:
Switch# show dot1x interface fastethernet1/0/3
Supplicant MAC 00d0.b71b.35de
AuthSM State = AUTHENTICATED
BendSM State = IDLE
PortStatus = AUTHORIZED
MaxReq = 2
HostMode = Single
Port Control = Auto
QuietPeriod = 60 Seconds
Re-authentication = Disabled
ReAuthPeriod = 3600 Seconds
ServerTimeout = 30 Seconds
SuppTimeout = 30 Seconds
TxPeriod = 30 Seconds
Guest-Vlan = 0
This is an example of output from the show dot1x statistics interface interface-id command. Table 2-20
describes the fields in the display.
Switch# show dot1x statistics interface fastethernet1/0/3
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 15 TxReq = 0 TxTotal = 15
RxStart = 4 RxLogoff = 0 RxRespId = 1 RxResp = 1
RxInvalid = 0 RxLenErr = 0 RxTotal= 6
RxVersion = 1 LastRxSrcMac 00d0.b71b.35de
Ta b l e 2-20 show dot1x statistics Field Descriptions
Field Description
TxReqId Number of Extensible Authentication Protocol (EAP)-request/identity frames
that have been sent.
TxReq Number of EAP-request frames (other than request/identity frames) that have
been sent.
TxTotal Number of Extensible Authentication Protocol over LAN (EAPOL) frames of any
type that have been sent.
RxStart Number of valid EAPOL-start frames that have been received.
RxLogoff Number of EAPOL-logoff frames that have been received.
RxRespId Number of EAP-response/identity frames that have been received.
RxResp Number of valid EAP-response frames (other than response/identity frames) that
have been received.