Cisco Catalyst 3750 Metro

2-460
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show errdisable recovery
show errdisable recovery
Use the show errdisable recovery user EXEC command to display the error-disable recovery timer
information.
show errdisable recovery
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Usage Guidelines A gbic-invalid error-disable reason refers to an invalid small form-factor pluggable (SFP) interface.
Examples This is an example of output from the show errdisable recovery command:
Note Though visible, the dhcp-rate-limit and unicast-flood reasons are not supported.
Switch> show errdisable recovery
ErrDisable Reason Timer Status
----------------- --------------
udld Disabled
bpduguard Disabled
security-violatio Disabled
channel-misconfig Disabled
vmps Disabled
pagp-flap Disabled
dtp-flap Disabled
link-flap Disabled
gbic-invalid Disabled
psecure-violation Disabled
gbic-invalid Disabled
dhcp-rate-limit Disabled
unicast-flood Disabled
loopback Disabled
Timer interval:300 seconds
Interfaces that will be enabled at the next timeout:
Interface Errdisable reason Time left(sec)
--------- ----------------- --------------
Fa1/0/4 link-flap 279
Note Though visible in the output, the unicast-flood field is not valid.
Release Modification
12.1(14)AX This command was introduced.