Cisco Catalyst 3750 Metro - Debug Mpls L2 Transport Vlan

B-38
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug mpls l2transport vlan
debug mpls l2transport vlan
Use the debug mpls l2transport vlan privileged EXEC command to enable debugging of the Ethernet
over multiprotocol label switching (EoMPLS) Layer 2 VLANs. Use the no form of this command to
disable debugging.
debug mpls l2transport vlan {control | distributed | switching}
no debug mpls l2transport vlan {control | distributed | switching}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Related Commands
control Display EoMPLS traffic control plane debug messages.
distributed Display EoMPLS traffic distributed switching control debug messages.
switching Display EoMPLS traffic packet switching debug messages.
Release Modification
12.1(14)AX This command was introduced.
Command Description
debug mpls atom Enables debugging of the Any Transport over multiprotocol label switching
(AToM) layer.
show debugging Displays information about the types of debugging that are enabled.
show mpls l2transport
vc
Displays information about the Ethernet over MPLS (EoMPLS) virtual
circuits (VCs).