Cisco Catalyst 3750 Metro - Debug Ip Sla Trace Twamp Session

B-29
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug ip sla trace twamp session
debug ip sla trace twamp session
Use the debug ip sla trace twamp session command in privileged EXEC mode to enable debugging
output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement Protocol
(TWAMP) normal session communication between the TWAMP sender and reflector. Use the no form
of this command to disable debugging output.
debug ip sla trace twamp session [source-ip ip-address | source-port port-number]
no debug ip sla trace twamp session [source-ip ip-address | source-port port-number]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The debug ip sla trace twamp session privileged EXEC command displays normal session
communication between the TWAMP sender and reflector.
Note Use the debug ip sla error twamp session command before using the debug ip sla trace twamp session
command because the debug ip sla error twamp session command generates less debugging output.
The debug ip sla trace twamp session command is supported in IPv4 networks.
The undebug ip sla trace twamp session command is the same as the no debug ip sla trace twamp
session command.
source-ip
ip-address
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified source. Specify the source using the client device IP address.
source-port
port-number
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified port.
Release Modification
12.2(52)SE This command was introduced.