Cisco Catalyst 3750 Metro - Show Mac Address-Table Static

2-552
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show mac address-table static
show mac address-table static
Use the show mac address-table static user EXEC command to display only static MAC address table
entries.
show mac address-table static [address mac-address] [interface interface-id] [vlan vlan-id]
Syntax Description
Command Modes User EXEC; address keyword available only in privileged EXEC mode.
Command History
Examples This is an example of output from the show mac address-table static command:
Switch> show mac address-table static
Mac Address Table
------------------------------------------
Vlan Mac Address Type Ports
---- ----------- ---- -----
All 0100.0ccc.cccc STATIC CPU
All 0180.c200.0000 STATIC CPU
All 0100.0ccc.cccd STATIC CPU
All 0180.c200.0001 STATIC CPU
All 0180.c200.0004 STATIC CPU
All 0180.c200.0005 STATIC CPU
4 0001.0002.0004 STATIC Drop
6 0001.0002.0007 STATIC Drop
Total Mac Addresses for this criterion: 8
address mac-address (Optional) Specify a 48-bit MAC address; the valid format is H.H.H
(available in privileged EXEC mode only).
interface interface-id (Optional) Specify an interface to match; valid interfaces include physical
ports and port channels.
vlan vlan-id (Optional) Display addresses for a specific VLAN. The range is 1 to 4094.
Release Modification
12.1(14)AX This command was introduced.