2-607
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
show udld
This is an example of output from the show udld interface-id command when the aggressive mode is
configured:
Switch# show udld gigabitethernet1/0/1
Interface Gi1/0/1
---
Port enable administrative configuration setting:Enabled / in aggressive mode
Port enable operational state:Enabled / in aggressive mode
Current bidirectional state:Unknown
Current operational state:Link down
Message interval:7
Time out interval:5
No neighbor cache information stored
Related Commands Command Description
udld (global configuration) Enables aggressive or normal mode in UDLD or sets the
configurable message timer time.
udld (interface configuration) Enables UDLD on an individual interface or prevents a fiber-optic
port from being enabled by the udld global configuration command.
udld reset Resets all interfaces shut down by UDLD and permits traffic to begin
passing through them again.
To Next Page
Loading...
