Cisco Catalyst 3750 Metro - Page 680

2-652
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
spanning-tree guard
ports. When the switch is operating in MST mode, BPDUs are not sent on nonboundary interfaces if the
interface is blocked by loop guard in all MST instances. On a boundary interface, loop guard blocks the
interface in all MST instances.
To disable root guard or loop guard, use the spanning-tree guard none interface configuration
command. You cannot enable both root guard and loop guard at the same time.
You can override the setting of the spanning-tree loopguard default global configuration command by
using the spanning-tree guard loop interface configuration command.
Examples This example shows how to enable root guard on all the VLANs associated with the specified port:
Switch(config)# interface fastethernet1/0/3
Switch(config-if)# spanning-tree guard root
This example shows how to enable loop guard on all the VLANs associated with the specified port:
Switch(config)# interface fastethernet1/0/3
Switch(config-if)# spanning-tree guard loop
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command Description
show running-config Displays the operating configuration. For syntax information,
use this link to the Cisco IOS Release 12.2 Command
Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/pr
od_command_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2
to navigate to the command.
spanning-tree cost Sets the path cost for spanning-tree calculations.
spanning-tree loopguard default Prevents alternate or root ports from becoming designated
ports because of a failure that leads to a unidirectional link.
spanning-tree mst cost Configures the path cost for MST calculations.
spanning-tree mst port-priority Configures an interface priority.
spanning-tree mst root Configures the MST root switch priority and timers based on
the network diameter.
spanning-tree port-priority Configures an interface priority.
spanning-tree vlan priority Sets the switch priority for the specified spanning-tree
instance.