Cisco Catalyst 3750 Metro - Page 903

B-77
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug platform tcam
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands
l3 {acl {input | output} |
ipv6 {acl {input | output} |
local | qos | secondary} |
local | qos | secondary}
Display Layer-3 field-based CAM look-up type debug messages. The
keywords have these meanings:
• acl {input | output}—Display input or output ACL look-up debug
messages.
• ipv6 {acl {input | output} | local | qos | secondary}—Display
IPv6-based look-up debug messages. Options include displaying
input or output ACL look-up, local forwarding look-up,
classification and QoS look-up, or secondary forwarding look-up
debug messages.
• local—Display local forwarding look-up debug messages.
• qos—Display classification and quality of service (QoS) look-up
debug messages.
• secondary—Display secondary forwarding look-up debug
messages.
read {reg | ssram | tcam} Display TCAM-read debug messages. The keywords have these
meanings:
• reg—Display TCAM-register read debug messages.
• ssram—Display synchronous static RAM (SSRAM)-read debug
messages.
• tcam—Display TCAM-read debug messages.
search Display supervisor-initiated TCAM-search results debug messages.
write {forw-ram | reg |
tcam}
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Release Modification
12.1(14)AX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.