Cisco Catalyst 3750 Metro - Page 952

C-22
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix C Catalyst 3750 Metro Switch Show Platform Commands
show platform port-asic
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
transmit {port-fifo | queue |
supervisor-sram} [asic number |
port number [asic number]]
Display transmit information. The keywords have these meanings:
• port-fifo—Display the contents of the port-FIFO information
register.
• queue—Display the contents of the queue information
register.
• supervisor-sram—Display supervisor SRAM information.
• asic number—(Optional) Display information for the
specified ASIC. The range is 0 to 1.
• port number—(Optional) Display information for the
specified port and ASIC number. The range is 0 to 27, where
0 is the supervisor and 1 to 25 are the ports.
vct [asic number | port number
[asic number]]
Display the VLAN compression table entries for the specified
ASIC or for the specified port and ASIC. The keywords have these
meanings:
• asic number—(Optional) Display information for the
specified ASIC. The range is 0 to 1.
• port number—(Optional) Display information for the
specified port and ASIC number. The range is 0 to 27, where
0 is the supervisor and 1 to 25 are the ports.
Release Modification
12.1(14)AX This command was introduced.