Cisco Catalyst 3750 Metro - Page 961

C-31
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix C Catalyst 3750 Metro Switch Show Platform Commands
show platform tcam
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
handle number Display the TCAM handle. The range is 0 to 4294967295.
log-results Display the TCAM log results.
table {acl | all | equal-cost-route
| ipv6 {acl | qos | secondary}
local | mac-address |
multicast-expansion | qos |
secondary | station | vlan-list}
Display lookup and forwarding table information. The keywords
have these meanings:
• acl—Display the access-control list (ACL) table.
• all—Display all the TCAM tables.
• equal-cost-route—Display the equal-cost-route table.
• ipv6—Display IPv6 information.
– acl—Display the IPv6 ACL-table information.
– qos—Display the IPv6 QoS-table information.
– secondary—Display the IPv6 secondary-table
information.
• local—Display the local table.
• mac-address—Display the MAC-address table.
• multicast-expansion—Display the IPv6 multicast-expansion
table.
• qos—Display the QoS table.
• secondary—Display the secondary table.
• station—Display the station table.
• vlan-list—Display the VLAN list table.
usage Display the CAM and forwarding table usage.
[[asic number [detail [invalid]] |
[index number [detail [invalid]] |
invalid | num number [detail
[invalid]] | invalid] | [invalid] |
[num number [detail [invalid]] |
invalid]]
Display information. The keywords have these meanings:
• asic number—Display information for the specified ASIC
device ID. The range is 0 to 15.
• detail [invalid]—(Optional) Display valid or invalid details.
• index number—(Optional) Display information for the
specified TCAM table index. The range is 0 to 32768.
• num number—(Optional) Display information for the
specified TCAM table number. The range is 0 to 32768.
Release Modification
12.1(14)AX This command was introduced.