User Manual Synertia® RF Generator 11
The information contained in this manual is subject to change by Comet Yxlon without prior notice.
1.4 Personal safety
1.4.1 Precautions for safe installation and operation
The following instructions must be observed by the user at any time:
• Do only install or operate this equipment if you are properly trained and qualified.
• Ensure that the shipping container does not show evidence of damage. If damage
is evident, follow your company’s procedure for damage claims.
WARNING
A damaged RF generator may cause health hazards!
For details, see section 1.3 “Hazards“.
Safety note 7: Warning - hazards
• Do not use the front panel handles for lifting or carrying the generator. The
handles are provided for final adjustment in a rack.
• Verify that input line voltage and current capacity are within specifications before
turning on the power supplies.
• Use proper electrostatic discharge (ESD) precautions.
• Before making any other connection to this device, ensure proper grounding.
Connect the earth terminal to a local earth with a copper wire that is sized
according to the applicable requirements.
• Only water-cooled generators: Ensure that the water-cooling flow is enabled and
that there are no fluid leaks or any leaks that enter the casing.
• Only air-cooled generators: Ensure that there is sufficient air flow possible to and
from the generator. Fans and vent holes must not be covered by adjacent
surfaces.
• Install and operate this device in an overvoltage category II installation only.
• Install and operate this device only in a pollution degree 2 or better environment,
which means an indoor location such as a computer room, office, or factory floor
where only non-conductive pollution occurs during operation. Occasionally,
condensation may create temporary conductivity when the device is not
operating. However, the device must not be operated wet.
To Next Page
Loading...