CTS FOS-3126-PLUS SERIES - Page 153

153
Source Port NO.: Specify a source port number (0~65535).
Source Port Range: Specify a source port range (The source port number is from 0 to
65535).
Destination Port Filter: Select “Any” to filter frames to any destination port. If “Specific” is
selected, you need to further specify a destination port number. If “Range” is selected, you
need to further specify a destination port range.
Destination Port NO.: Specify a destination port number (0~65535).
Destination Port Range: Specify a destination port range (The source port number is from
0 to 65535).
TCP FIN: Select “0” to indicate that the FIN value in TCP header is zero; “1” to indicate the
FIN value in TCP header is one. Select “any” to indicate either 1 or 0.
TCP SYN: Select “0” to indicate that the SYN value in TCP header is zero; “1” to indicate
the SYN value in TCP header is one. Select “any” to indicate either 1 or 0.
TCP RST: Select “0” to indicate that the RST value in TCP header is zero; “1” to indicate
the RST value in TCP header is one. Select “any” to indicate either 1 or 0.
TCP PSH: Select “0” to indicate that the PSH value in TCP header is zero; “1” to indicate
the PSH value in TCP header is one. Select “any” to indicate either 1 or 0.
TCP ACK: Select “0” to indicate that the ACK value in TCP header is zero; “1” to indicate
the ACK value in TCP header is one. Select “any” to indicate either 1 or 0.
TCP URG: Select “0” to indicate that the URG value in TCP header is zero; “1” to indicate
the URG value in TCP header is one. Select “any” to indicate either 1 or 0.