Switch(config)# no snmp-
server trap-type [all |anti-
bcast |auth-fail | case-fan |
cold-start | port-link |
power-down | sfp | storm |
upper-limit [0-148810] pps
| warm-start]
[all |anti-
bcast |auth-
fail | case-fan
| cold-start |
port-link |
power-down |
sfp | storm |
upper-limit
[0-148810]
pps | warm-
start]
Specify a trap type that will not be sent
when a certain situation occurs.
Switch(config)# show snmp-server trap-
type
Show the current enable/disable status of
each type of trap.
Switch(config)# snmp-server trap-type all
All types of SNMP traps will be sent.
2.6.22 Switch-info Command
1. Set up the Managed Switch’s basic information, including company name, hostname,
system name, etc..
Switch(config)# switch-info
company-name
[company_name]
Enter a company name, up to 55
alphanumeric characters, for this Managed
Switch.
Switch(config)# switch-info
system-contact
[sys_contact]
Enter contact information for this Managed
switch, up to 55 alphanumeric characters.
Switch(config)# switch-info
system-location
[sys_location]
Enter a brief description, up to 55
alphanumeric characters, of the Managed
Switch location. Like the name, the
location is for reference only, for example,
“13th Floor”.
Switch(config)# switch-info
system-name [sys_name]
Enter a unique name, up to 55
alphanumeric characters, for this Managed
Switch. Use a descriptive name to identify
the Managed Switch in relation to your
network, for example, “Backbone 1”. This
name is mainly used for reference only.
Switch(config)# switch-info
host-name [host_name]
Enter a new hostname, up to 15
alphanumeric characters, for this Managed
Switch. By default, the hostname prompt
shows the model name of this Managed
Switch. You can change the factory-
assigned hostname prompt to the one that
is easy for you to identify during network
configuration and maintenance.
To Next Page
Loading...
