4.4.1 Switch Configuration
Click the option Switch Configuration from the Switch Management menu and then the
following screen page appears.
Maximum Frame Size: Specify the maximum frame size between 1518 and 9600 bytes. The
default maximum frame size is 9600bytes.
MAC Address Aging Time: Specify MAC Address aging time between 0 and 4080 seconds. “0”
means that MAC addresses will never age out.
SFP Safety Temperature: Enter the specific temperature for the Managed Switch to detect the
SFP DMI safety range. (Default 0~70C)
SFP Safety Voltage: Enter the specific Voltage for the Managed Switch to detect the SFP DMI
safety range. (Default 3~3.6V)
SFP Safety TX Bias: Enter the specific Bias for the Managed Switch to detect the SFP DMI safety
range. (Default 400mA)
SFP Normal TX Porwer range: Enter the TX power value. The allowable range is between -9999
and 99999.
SFP Normal RX Power range: Enter the RX power value. The allowable range is between -9999
and 99999.
Layer 2 Control Protocol
0180C200000X: Select either “Not Filter” or “Filter”. When “Filter” is selected, packets from the
address ranging from 0180C2000000 to 0180C200000F will be dropped. Multicast MAC
addresses from 0180C2000000 to 0180C200000F are reserved for use by 802.1/802.3 protocols.
The purpose for each multicast address is described briefly below:
0180C2000000: (All bridges) It is used for BPDUs and must be recognized by RBridges
due to RBridge port participation in spanning tree as a leaf.
0180C2000001: 802.3 Clause 31 use, i.e. Full Duplex PAUSE operation.
To Next Page
Loading...
Need help?
General
