Telnet Port: Specify the desired TCP port number for the Telnet console. The default TCP port
number of the Telnet is 23.
System Time Out: Specify the desired time that the Managed Switch will wait before
disconnecting an inactive console/telnet. Specifying “0” means an inactive connection will never
be disconnected.
4.3.4 Time Server Configuration
Click the option Time Server Configuration from the Network Management menu and then the
following screen page appears.
Time Synchronization: To enable or disable time synchronization.
Time Server Address: NTP time server address.
2nd Time Server Address: When the default time server is down, the Managed Switch will
automatically connect to the 2nd time server.
Synchronization Interval: The time interval to synchronize from NTP time server.
Time Zone: Select the appropriate time zone from the pull-down menu.
Daylight Saving Time: To enable or disable the daylight saving time function. It is a way of
getting more daytime hour(s) by setting the time to be hour(s) ahead in the morning.
Daylight Saving Time Offset: Click the pull-down menu to select the time offset of daylight
saving time.
NOTE: SNTP is used to get the time from those NTP servers. It is recommended that the
time server is in the same LAN with the Managed Switch or at least not too far away. In
this way, the time will be more accurate.
To Next Page
Loading...
Need help?
General
