CTS FOS-3126-PLUS SERIES User Manual

25
Show command
Switch(config)# show interface
Show each interface‟s port configuration
including media type, forwarding state,
speed, duplex mode, flow control and link
up/down status.
Switch(config)# show interface
[port_list]
[port_list]
Show the selected interface‟s port
configuration.
Switch(config)# show interface
status
Show each interface‟s port status
including media type, forwarding state,
speed, duplex mode, flow control and link
up/down status.
Switch(config)# show interface
status [port_list]
[port_list]
Show the selected interface‟s port status.
Interface command example
Switch(config)# interface 1-3
Enter port 1 to port 3‟s interface mode.
Switch(config-if-1-3)# auto-negotiation
Set the selected interfaces‟ to auto-
negotiation.
Switch(config-if-1-3)# duplex full
Set the selected interfaces‟ to full duplex
mode.
Switch(config-if-1-3)# flowcontrol
Enable the selected interfaces‟ flow
control function.
Switch(config-if-1-3)# speed 1000
Set the selected ports‟ speed to
1000Mbps.
Switch(config-if-1-3)# media-type sfp
Set the selected ports‟ media type to fiber.
Switch(config-if-1-3)# shutdown
Administratively disable the selected
ports‟ status.
2.6.5 ACL Command
Command
Parameter
Description
Switch(config)# acl [1-110]
[1-110]
The total number of ACL rule can be
created is 110. Use this command to
enter ACL configuration mode for each
ACL rule. When you enter each ACL
rule, you can further configure detailed
settings for this rule.
Switch(config-acl-RULE)#
action [deny]
[deny]
Deny the action for this rule.
Switch(config-acl-RULE)#
action port-copy [port]
[port]
Specify a port number (1~26). This
command will send a copy of packets
to the specified port.
Switch(config-acl-RULE)#
action rate-limiter-id [1-14]
[1-14]
Specify a rate limiter ID.
Switch(config-acl-RULE)#
action shutdown
Shutdown the interface.

CTS FOS-3126-PLUS SERIES Specifications

General

Brand	CTS
Model	FOS-3126-PLUS SERIES
Category	Switch
Language	English