EasyManua.ls Logo

CTS FOS-3126-PLUS SERIES - Entering Interface Numbers; No Command; Show Command

Default Icon
205 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
2.6.1 Entering Interface Numbers
In the Global Configuration mode, you can configure a command that only applies to interfaces
specified. For example, you can set up each interfaces VLAN assignment, speeds, or duplex
modes. To configure, you must first enter the interface number. There are four ways to enter your
interface numbers to signify the combination of different interfaces that apply a command or
commands.
Commands
Description
Switch(config)# interface 1
Switch(config-if-1)#
Enter a single interface. Only interface 1 will
apply commands entered.
Switch(config)# interface 1,3,5
Switch(config-if-1,3,5)#
Enter three discontinuous interfaces,
separated by commas. Interface 1, 3, 5 will
apply commands entered.
Switch(config)# interface 1-3
Switch(config-if-1-3)#
Enter three continuous interfaces. Use a
hyphen to signify a range of interface
numbers. In this example, interface 1, 2, and
3 will apply commands entered.
Switch(config)# interface 1,3-5
Switch(config-if-1,3-5)#
Enter a single interface number together with
a range of interface numbers. Use both
comma and hypen to signify the combination
of different interface numbers. In this
example, interface 1, 3, 4, 5 will apply
commands entered.
2.6.2 No Command
Almost every command that you enter in Configuration mode can be negated using no command
followed by the original or similar command. The purpose of no command is to disable a function,
remove a command, or set the setting back to the default value. In each sub-section below, the
use of no command to fulfill different purposes will be introduced.
2.6.3 Show Command
The show command is very important for network administrators to get information about the
device, receive outputs to verify a commands configurations or troubleshoot a network
configuration error. It can be used in Privileged or Configuration mode. The following describes
different uses of show command.
1. Display system information
Enter show switch-info command in Privileged or Configuration mode, and then the following
similar screen page will appear.

Table of Contents

Related product manuals