4.4.11.1 IGMP Configuration
Select the option IGMP Configuration from the IGMP Snooping menu and then the following
screen page appears.
Snooping: When enabled, the Managed Switch will monitor network traffic and determine which
hosts to receive multicast traffic.
Unregistered IPMC Flooding: Set forwarding mode for unregistered (not-joined) IP multicast
traffic. The traffic will flood when enabled. However, the traffic will be forwarded to router-ports
only when disabled.
Query Interval: The Query Interval is used to set the time between transmitting IGMP queries,
entries between 1 ~ 6000 seconds are allowed. (Default value 125, One Unit =1 second)
Query Response Interval: This determines the maximum amount of time allowed before sending
an IGMP response report. (Default value 100, One Unit=0.1 second)
Immediate Leave: The Immediate Leave option may be enabled or disabled. When enabled, this
allows an interface to be ignored without sending group-specific queries. The default setting is
“Disabled”.
Router Ports: When ports are connected to the IGMP administrative routers, they should be set
to “Y”. Otherwise, the default “N” will be applied.
4.4.11.2 IGMP VLANID Configuration
Select the option IGMP VLAN Configuration from the IGMP Snooping menu and then the
following screen page with the ability information of IGMP Snooping and Querying in VLAN(s)
appears.
Select the current VLAN(s) and click Edit to view and edit the ability settings.
To Next Page
Loading...
