IP Security: Click the pull-down menu to enable or disable the IP security function. If enabled,
Community may access the Managed Switch only through the management station, which has the
exact IP address specified in IP address field below. If disabled, Community can access the
Managed Switch through any management stations.
IP Address: Specify the IP address used for IP Security function.
SNMP Level: Click the pull-down menu to select the desired privilege for the SNMP operation
NOTE: When the community browses the Managed Switch without proper access right,
the Managed Switch will not respond. For example, if a community only has Read & Write
privilege, then it cannot browse the Managed Switch’s user table.
4.3.6 Trap Destination
Click the option Trap Destination from the Network Management menu and then the following
screen page appears.
State: Enable or disable the function of sending trap to the specified destination.
Destination: Enter the specific IP address of the network management system that will receive
the trap.
Community: Enter the community name of the network management system.
To Next Page
Loading...
Need help?
General
