CTS FOS-3126-PLUS SERIES - MVR Command

57
2.6.15 MVR Command
Command
Parameter
Description
Switch(config)# mvr
Enable MVR function.
Switch(config)# mvr vlan [1-4094]
[1-4094]
Specify a VID (1~4094) to create a MVR
VLAN.
Switch(config)# mvr group [1-4094]
[E.F.G.H] [E.F.G.H]
[1-4094]
Specify a registered MVR VID (1~4094)
and add specify the multicasting
channel that would belong to MVR
VLAN.
[E.F.G.H]
[E.F.G.H]
Specify the low and high multicast IP
address ranging from 224.0.1.0 to 238.
255.255.255.
No command
Switch(config)# no mvr
Disable MVR function.
Switch(config)# no mvr group [1-
4094] [E.F.G.H] [E.F.G.H]
[1-4094]
Remove a MVR multicasting group.
[E.F.G.H]
[E.F.G.H]
Switch(config-if-PORT-PORT)# no
mvr vlan [1-4094]
[1-4094]
Remove a registered MVR VLAN.
Show command
Switch(config)# show mvr
Show or verify current MVR settings.
Switch(config)# show mvr group
Show or verify MVR group settings.
MVR command example
Switch(config)# mvr
Enable MVR function.
Switch(config)# mvr vlan 50
Create a MVR VLAN 50.
Switch(config)# mvr group 50 224.10.0.10
238.10.0.10
Add a multicasting IP group to the
registered MVR VLAN.
Use “Interface” command to configure a group of ports’ MVR settings.
MVR & Interface command
Parameter
Description
Switch(config)# interface
[port_list]
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-
PORT)# mvr vlan [1-4094]
type [receiver | source]
[1-4094]
Specify a VLAN ID for this multicast
VLAN.
[receiver |source]
Indicate whether the selected ports are
receiver or source ports.
No command
Switch(config-if-PORT-
PORT)# no mvr vlan [1-4094]
[1-4094]
Delete this Multicast VLAN.
Show command
Switch(config)# show mvr
Show or verify current MVR settings.
Switch(config)# show mvr group
Show or verify MVR group settings.