CTS FOS-3126-PLUS SERIES - SNMP-Server Command

70
No command
Switch(config)# no switch sfp temperature
Set the SFP temperature back to
the default setting.
Switch(config)# no switch sfp tx-bias
Set the SFP TX bias power back
to the default setting.
Switch(config)# no switch sfp tx-power
Set the SFP TX power value back
to the default setting.
Switch(config)# no switch sfp rx-power
Set the SFP RX power value
back to the default setting.
Switch(config)# no switch sfp voltage
Set the SFP voltage value back to
the default setting.
Show command
Switch(config)# show switch sfp
Show the slide-in SFP module‟s
current temperature, voltage and
TX Bias power.
Switch(config)# show switch bpdu
Show current BPDU information.
Switch(config)# show switch mtu
Show current maximum
transmission unit setting.
Switch command example
Switch(config)# switch sfp temperature 0 70
Set the slide-in SFP safety
temperature rang to 0-70 degrees
Celsius.
Switch(config)# switch sfp tx-bias 400
Set the slide-in SFP safety TX
Bias to 400.
Switch(config)# switch sfp voltage 3 3.6
Set the slide-in SFP safety
voltage in a range of 3 and 3.6.
Switch(config)# switch bpdu 00-0F permit
Permit packets from the address
ranging from 0180C2000000 to
0180C200000F.
Switch(config)# switch bpdu 20-2F permit
Permit packets from the address
ranging from 0180C2000020 to
0180C200002F.
Switch(config)# switch bpdu 10 permit
Permit packets from the address
0180C2000010.
Switch(config)# switch mtu 9600
Set the maximum transmission
unit to 9600 bytes.
2.6.21 SNMP-Server Command
1. Create a SNMP community and set up detailed configurations for this community.
Snmp-server command
Parameter
Description
Switch(config)# snmp-
server
Enable SNMP server function globally.
Switch(config)# snmp-
server community
[community]
[community]
Specify a SNMP community name of up to
20 alphanumeric characters.
Switch(config-community-
NAME)# active
Enable this SNMP community account.