Baud Rate: 9600 bps, RS-232 setting, view-only field.
Stop Bits: 1, RS-232 setting, view-only field.
Parity Check: None, RS-232 setting, view-only field.
Word Length: 8, RS-232 setting, view-only field.
Flow Control: None, RS-232 setting, view-only field.
Telnet Port: Specify the desired TCP port number for the Telnet console. The default TCP port
number of the Telnet is 23.
System Time Out: Specify the desired time that the Managed Switch will wait before
disconnecting an inactive console/telnet session. Valid range:1-1440 seconds or minutes.
Unit: Specify the unit for the System Time Out parameter.
Web Time Out: Specify the desired time that the Managed Switch will wait before disconnecting
an inactive web session. Valid range:1-1440 minutes.
Console Login Fail Retry Times: Specify the desired times that the Managed Switch will allow
the user to retry to login the system via console if the console login fails. Valid range: 1-10.
Console Login Fail Block Time: Specify the desired time that the Managed Switch will unblock
the console for user’s login if the accumulated retries times exceed the value you set up in
Console Login Fail Retry Times parameter.
To Next Page
Loading...
Need help?
General
