Configure Key Value:
Select “Key Value” from the pull-down menu of Select Setting.
Ports in an aggregated link group must have the same LACP port key. In order to allow a port to
join an aggregated group, the port key must be set to the same value. The range of key value is
between 0 and 255. When key value is set to 0, the port key is automatically set by the Managed
Switch.
Configure Port Role:
Select “Role” from the pull-down menu of Select Setting. This allows LACP to be enabled (active
or passive) or disabled on each port.
To Next Page
Loading...
