6. IEEE802.1q VLAN Table: View the IEEE802.1q VLAN Table of the Managed Switch.
7. ARP Table: View the list of all entries of mapping an IP address to a unique MAC address.
8. LACP Monitor: View the LACP port status and statistics.
9. RSTP Monitor: View RSTP VLAN Bridge, Port Status, and Statistics.
10. 802.1X Monitor: View port status and Statistics.
11. IGMP/MLD Monitor: View-only field that shows IGMP status and Groups table.
12. SFP Information: View the current port’s SFP information, e.g. speed, Vendor ID, Vendor S/N,
etc.. SFP port state shows current DMI (Diagnostic monitoring interface) temperature, voltage,
TX Bias, etc..
13. DHCP Snooping: View the DHCP learning table, etc..
14. MAC Limiters Status: View the status of MAC limiting configuration.
15. MAC Address Table: List current MAC addresses learned by the Managed Switch.
16. Layer 2 Protocol Tunneling Status: View the state of Layer 2 protocol data units (PDUs) and
their encapsulation and decapsulation counters of each port.
17. LLDP Status: View the TLV information sent by the connected device with LLDP-enabled.
18. Loop Detection Status: View the Loop Detection status of each port.
To Next Page
Loading...
