Refresh Page Interval: Automatically updates CPU temperature of the system at a specified
interval in seconds. Please note that the value you assign in this parameter is temporarily used
and will not be saved into the configuration file of the Managed Switch. This value will not be
applied into the next system boot-up.
Start Auto Update: Click “Start Auto Update” to activate auto-update.
Stop Auto Update: Click “Stop Auto Update” to deactivate auto-update.
Update: Click “Update“ to refresh the latest CPU temperature at a time.
High Temperature Threshold: Specify CPU temperature threshold. Valid range: 0~60 degrees
centigrade.
If the detected CPU temperature is over the threshold you configure, the alarm message ”CPU
temperature is over threshold” will be sent based on the configuration in the folloiwng Threshold
Interval and Continuous Alarm parameters.
NOTE: Any new changes done on this parameter will be taken effect immediately during
the system execution, the temperature sensor will begin to check CPU temperature and
decide whether to send the alarm/normal message or not upon the last status. Refer to
Table 4-1.
Last
Status
Detected
Status
Send the “CPU
temperature is at or
under threshold” normal
message.
Send the “CPU
temperature is over
threshold” alarm
message.
Table 4-1
Threshold Interval: Specify the time interval of sending cpu-temperature alarm message in
seconds.
NOTE: Any new changes done on this parameter will be taken effect immediately during
the system execution, the temperature sensor will begin to check CPU temperature and
decide whether to send the alarm/normal message or not upon the last status. Refer to
Table 4-2.
To Next Page
Loading...
Need help?
General
