Current Boot Image: The image that is currently using.
Configured Boot Image: The image you would like to use after rebooting.
Image-1 Version: Display the firmware version 1 (image-1) used in this device.
Image-2 Version: Display the firmware version 2 (image-2) used in this device.
M/B Version: Display the main board version.
Serial Number: Display the serial number of this Managed Switch.
Date Code: Display the date code of the Managed Switch firmware.
Up Time: Display the up time since last restarting.
Local Time: Display the local time of the system.
FAN State: Display the status of FAN1 and FAN2.
Power A/B: Display the installation status, the type of power source and state of Power A and
Power B.
CPU Temperature: Display the current CPU temperature of this device.
2. Display or verify currently-configured settings
Refer to the following sub-sections. “Interface command”, “IP command”, “MAC command”, “QoS
command”, “Security command”, “SNMP-Server command”, “User command”, “VLAN command”
sections, etc.
3. Display interface information or statistics
Refer to “Show interface statistics command” and “Show sfp information command” sections.
4. Show default, running and startup configurations
Refer to “show default-config copmmand”, “show running-config command” and “show start-up-
config command” sections.
5. Show CPU & Memory Statistics
Show CPU utilization and memory usage rate. Refer to “show switch-info command” section.
6. Show ARP
Show ARP information. Refer to “show arp command” section.
To Next Page
Loading...
Need help?
General
