CTS FOS-3128 Series - Page 46

46
Switch(config)# ip igmp
snooping mcast-router [port_list]
[port_list]
Specify multicast router ports.
Switch(config)# ip igmp
snooping query-interval [1-6000]
[1-6000]
Specify the Query time interval of
IGMP/MLD querier. This is used to set up
the time interval between transmitting
IGMP/MLD queries. (Range:1-6000
seconds)
Switch(config)# ip igmp
snooping vlan [1-4094]
[1-4094]
Specify a VLAN ID. This enables
IGMP/MLD Snooping for the specified
VLAN.
Switch(config)# ip igmp
snooping vlan [1-4094] query
[1-4094]
Enable a querier for the specified VLAN.
No command
Switch(config)# no ip igmp
snooping
Disable IGMP/MLD Snooping function.
Switch(config)# no ip igmp
snooping flooding
Disable Unregistered IPMC Flooding
function.Traffic will forward to router-ports
only when disabled.
Switch(config)# no ip igmp
snooping immediate-leave
Disable immediate leave function.
Switch(config)# no ip igmp
snooping max-response-time
Reset maximum response time back to the
default.
Switch(config)# no ip igmp
snooping mcast-router [port_list]
[port_list]
Remove the selected port(s) from the
router port list.
Switch(config)# no ip igmp
snooping query-interval
Reset Query interval value back to the
default. (100 seconds)
Switch(config)# no ip igmp
snooping vlan [1-4094]
[1-4094]
Disable IGMP/MLD Snooping for the
specified VLAN.
Switch(config)# no ip igmp
snooping vlan [1-4094] query
[1-4094]
Disable a querier for the specified VLAN.
Show command
Switch(config)# show ip igmp
snooping
Show the current IGMP/MLD snooping
configuration.
Switch(config)# show ip igmp
snooping groups
Show IGMP snooping groups table.
Switch(config)# show ip igmp
snooping status
Show IGMP Snooping status.
Switch(config)# show ip mld
snooping groups
Show MLD snooping groups table.
Switch(config)# show ip mld
snooping status
Show MLD Snooping status.