D-Link DGS-3000 series - Config Firmware Image

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
121
Format
reset {[config | system]} {force_agree}
Parameters
config - (Optional) All parameters are reset to default settings. However, the device will neither
save or reboot.
system - (Optional) All parameters are reset to default settings, and the Switch will reset to
factory default settings, save and reboot.
force_agree - (Optional) The reset command will be executed immediatedly without further
confirmation.
Restrictions
Only Administrators can issue this command.
Example
To reset the Switch:
DGS-3000-26TC:admin#reset system
Command: reset system
Are you sure you want to proceed with system reset?(y/n)
y-(reset all include configuration, save, reboot )
n-(cancel command) y
Reboot & Load Factory Default Configuration...
Saving configurations and logs to NV-RAM...... Done.
Please wait, the switch is rebooting...
10-12 config firmware image
Description
This command is used to select a firmware file as a boot up file. This command is required to be
supported when multiple firmware images are supported.
Format
config firmware image <path_filename64>boot_up
Parameters
<path_filename64> - Specifies a firmware file on the device file system.
boot_up - Specifies the firmware as the boot up firmware.
Restrictions
Only Administrators can issue this command.