D-Link DGS-3000 series - Config Authen Parameter Attempt

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
73
5-24 config authen parameter response_timeout
Description
This command is used to configure the amount of time waiting or user input on console, TELNET,
SSH application.
Format
config authen parameter response_timeout <int 0-255>
Parameters
<int 0-255> - The amount of time for user input on console, TELNET or SSH. 0 means there is
no time out. This value must be between 0 and 255. Default value is 30 seconds.
Restrictions
Only Administrators can issue this command.
Example
To configure the amount of time waiting or user input to be 60 seconds:
DGS-3000-26TC:admin#config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DGS-3000-26TC:admin#
5-25 config authen parameter attempt
Description
This command is used to configure the maximum attempts for user's trying to login or promote the
privilege on console, TELNET, or SSH application.
Format
config authen parameter attempt <int 1-255>
Parameters
<int 1-255> - The amount of attempts for user's trying to login or promote the privilege on
console, TELNET or SSH. This value must be between 1 and 255. Default value is 3.
Restrictions
Only Administrators can issue this command.