D-Link DGS-3000 series - Chapter 22 Digital Diagnostic Monitoring (DDM) Commands

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
218
Chapter 22 Digital Diagnostic
Monitoring (DDM)
Commands
config ddm [trap | log] [enable | disable]
config ddm ports [<portlist> | all] [[temperature_threshold | voltage_threshold |
bias_current_threshold | tx_power_threshold | rx_power_threshold] {high_alarm <float> |
low_alarm <float> | high_warning <float> | low_warning<float>} | {state [enable | disable] |
shutdown [alarm |warning | none]}]
show ddm
show ddm ports {<portlist>} [status | configuration]
22-1 config ddm
Description
The command configures the DDM log and trap action when encountering an exceeding alarm or
warning thresholds event.
Format
config ddm [trap | log] [enable | disable]
Parameters
trap - Specifies whether to send traps, when the operating parameter exceeds the corresponding
threshold. The DDM trap is disabled by default.
log - Specifies whether to send a log, when the operating parameter exceeds the corresponding
threshold. The DDM log is enabled by default.
enable - Specifies to enable the log or trap sending option.
disable - Specifies to disable the log or trap sending option.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure DDM log state to enable:
DGS-3000-26TC:admin#config ddm log enable
Command: config ddm log enable
Success.
DGS-3000-26TC:admin#
To configure DDM trap state to enable: